How to clean the residual stains on the high temperature fireproof clothing?
Release time:
2022-12-12
High temperature fireproof clothing is processed through the surface layer, heat insulation board, comfortable layer and other double-layer textiles, such as part of the raw materials can be allowed to make single-sided or double-layer. The surface of thermal insulation clothing shall be made of aluminum and platinum surface materials with reflective radiation heat, and shall be able to meet the performance requirements of basic clothing design process standards and auxiliary materials matching standardization.
High temperature fireproof clothingIt is processed by double-layer textiles such as surface layer, heat insulation board and comfortable layer. The raw materials of this kind can be made into single-sided or double-layer. The surface of thermal insulation clothing shall be made of aluminum and platinum surface materials with reflective radiation heat, and shall be able to meet the performance requirements of basic clothing design process standards and auxiliary materials matching standardization.
High temperature fireproof clothingWhat is more needed is that flame retardant cloth is coated with aluminum and platinum. Flame retardant cloth is divided into two kinds: pure cotton flame retardant twill gauze card and C/N cotton brocade flame retardant fabric. After coated with aluminum and platinum, it not only has better flame retardant performance, but also the outer aluminum and platinum layer can play a certain role in preventing radiation heat.
How to maintain forest fire protection clothing
1. After each application is taken off, check the condition of the fire protection clothing and see if there is any damage.
2. If you want to clearHigh temperature fireproof clothingResidual stains, use daily tap water and neutral soap, use detergent if needed,. Use only in environmentally contaminated locations and be cautious as the detergent may damage the aluminized surface.
3, if the fire clothing has been touched with chemicals, or found bubble condition, must clean all aluminized surface. If the high temperature fire clothing left on the hydraulic oil or grease residue, it must be cleaned with neutral soap.
4. Before storing the fire-proof clothing again, it is necessary to determine whether it is dry and impatient, and try not to fold it when it is dried.
5. If the surface of the fireproof clothing surges with a small square meter but is not seriously burned or damaged, it can be repaired with an aluminized spray gun. If the interior of the fire suit is damaged, the fire suit needs to be removed and replaced.
Today's forest fire protection clothing has long been more and more various, there are many different unique styles, in all kinds of conditions can play its own matching function.
Some forest fire protection clothing has very good fire safety characteristics, but its own air permeability level is weak. When firefighters wear fire protection clothing for a long time, their own inhalation is difficult to guarantee, and the actual effect of a lot of sweating is not very good., May cause some damage to the human body of firefighters.
Some forest fire protection clothing itself may melt and drip after being ignited by fire for a long time, resulting in bending of the overall fire protection clothing situation. It is not only unable to give the relevant practical effect of fire safety for firefighters, but may even cause further damage to firefighters.
There are also some forest fire protection clothing itself in the design of processing technology, in case of fire combustion is easy to produce indoor formaldehyde, resulting in wearing firefighters themselves inhaled or long-term exposure to indoor formaldehyde, resulting in spiritual destruction, not only reduce the high efficiency of emergency rescue, but also naturally cause harm to firefighters themselves.
Key words:
High temperature fireproof clothing
Previous Page
RELATED INFORMATION
Office address:Room 901, Unit 1, Building 2, Liandong U Valley Qingdao Science & Innovation Center, No.1001 Chongqing Middle Road, Xiangtan Road Subdistrict, Licang District, Qingdao City, Shandong Province, China
Factory Address: Li Xin Community, Chengyang District, Qingdao City, Shandong Province